diff options
Diffstat (limited to 'hw/watchdog/cmsdk-apb-watchdog.c')
| -rw-r--r-- | hw/watchdog/cmsdk-apb-watchdog.c | 34 |
1 files changed, 27 insertions, 7 deletions
diff --git a/hw/watchdog/cmsdk-apb-watchdog.c b/hw/watchdog/cmsdk-apb-watchdog.c index e4d25a25f7..ed5ff4257c 100644 --- a/hw/watchdog/cmsdk-apb-watchdog.c +++ b/hw/watchdog/cmsdk-apb-watchdog.c @@ -196,16 +196,13 @@ static void cmsdk_apb_watchdog_write(void *opaque, hwaddr offset, switch (offset) { case A_WDOGLOAD: - /* - * Reset the load value and the current count, and make sure - * we're counting. - */ + /* Reset the load value and the current count. */ ptimer_transaction_begin(s->timer); ptimer_set_limit(s->timer, value, 1); - ptimer_run(s->timer, 0); ptimer_transaction_commit(s->timer); break; - case A_WDOGCONTROL: + case A_WDOGCONTROL: { + uint32_t prev_control = s->control; if (s->is_luminary && 0 != (R_WDOGCONTROL_INTEN_MASK & s->control)) { /* * The Luminary version of this device ignores writes to @@ -215,8 +212,25 @@ static void cmsdk_apb_watchdog_write(void *opaque, hwaddr offset, break; } s->control = value & R_WDOGCONTROL_VALID_MASK; + if (R_WDOGCONTROL_INTEN_MASK & (s->control ^ prev_control)) { + ptimer_transaction_begin(s->timer); + if (R_WDOGCONTROL_INTEN_MASK & s->control) { + /* + * Set HIGH to enable the counter and the interrupt. Reloads + * the counter from the value in WDOGLOAD when the interrupt + * is enabled, after previously being disabled. + */ + ptimer_set_count(s->timer, ptimer_get_limit(s->timer)); + ptimer_run(s->timer, 0); + } else { + /* Or LOW to disable the counter and interrupt. */ + ptimer_stop(s->timer); + } + ptimer_transaction_commit(s->timer); + } cmsdk_apb_watchdog_update(s); break; + } case A_WDOGINTCLR: s->intstatus = 0; ptimer_transaction_begin(s->timer); @@ -305,8 +319,14 @@ static void cmsdk_apb_watchdog_reset(DeviceState *dev) s->resetstatus = 0; /* Set the limit and the count */ ptimer_transaction_begin(s->timer); + /* + * We need to stop the ptimer before setting its limit reset value. If the + * order is the opposite when the code executes the stop after setting a new + * limit it may want to recalculate the count based on the current time (if + * the timer was currently running) and it won't get the proper reset value. + */ + ptimer_stop(s->timer); ptimer_set_limit(s->timer, 0xffffffff, 1); - ptimer_run(s->timer, 0); ptimer_transaction_commit(s->timer); } |