diff options
Diffstat (limited to 'hw/misc')
| -rw-r--r-- | hw/misc/mps2-scc.c | 101 |
1 files changed, 91 insertions, 10 deletions
diff --git a/hw/misc/mps2-scc.c b/hw/misc/mps2-scc.c index 02a80bacd7..18be74157e 100644 --- a/hw/misc/mps2-scc.c +++ b/hw/misc/mps2-scc.c @@ -37,6 +37,7 @@ REG32(CFG3, 0xc) REG32(CFG4, 0x10) REG32(CFG5, 0x14) REG32(CFG6, 0x18) +REG32(CFG7, 0x1c) REG32(CFGDATA_RTN, 0xa0) REG32(CFGDATA_OUT, 0xa4) REG32(CFGCTRL, 0xa8) @@ -62,25 +63,46 @@ static int scc_partno(MPS2SCC *s) /* Is CFG_REG2 present? */ static bool have_cfg2(MPS2SCC *s) { - return scc_partno(s) == 0x524 || scc_partno(s) == 0x547; + return scc_partno(s) == 0x524 || scc_partno(s) == 0x547 || + scc_partno(s) == 0x536; } /* Is CFG_REG3 present? */ static bool have_cfg3(MPS2SCC *s) { - return scc_partno(s) != 0x524 && scc_partno(s) != 0x547; + return scc_partno(s) != 0x524 && scc_partno(s) != 0x547 && + scc_partno(s) != 0x536; } /* Is CFG_REG5 present? */ static bool have_cfg5(MPS2SCC *s) { - return scc_partno(s) == 0x524 || scc_partno(s) == 0x547; + return scc_partno(s) == 0x524 || scc_partno(s) == 0x547 || + scc_partno(s) == 0x536; } /* Is CFG_REG6 present? */ static bool have_cfg6(MPS2SCC *s) { - return scc_partno(s) == 0x524; + return scc_partno(s) == 0x524 || scc_partno(s) == 0x536; +} + +/* Is CFG_REG7 present? */ +static bool have_cfg7(MPS2SCC *s) +{ + return scc_partno(s) == 0x536; +} + +/* Does CFG_REG0 drive the 'remap' GPIO output? */ +static bool cfg0_is_remap(MPS2SCC *s) +{ + return scc_partno(s) != 0x536; +} + +/* Is CFG_REG1 driving a set of LEDs? */ +static bool cfg1_is_leds(MPS2SCC *s) +{ + return scc_partno(s) != 0x536; } /* Handle a write via the SYS_CFG channel to the specified function/device. @@ -144,8 +166,16 @@ static uint64_t mps2_scc_read(void *opaque, hwaddr offset, unsigned size) if (!have_cfg3(s)) { goto bad_offset; } - /* These are user-settable DIP switches on the board. We don't + /* + * These are user-settable DIP switches on the board. We don't * model that, so just return zeroes. + * + * TODO: for AN536 this is MCC_MSB_ADDR "additional MCC addressing + * bits". These change which part of the DDR4 the motherboard + * configuration controller can see in its memory map (see the + * appnote section 2.4). QEMU doesn't model the MCC at all, so these + * bits are not interesting to us; read-as-zero is as good as anything + * else. */ r = 0; break; @@ -164,6 +194,12 @@ static uint64_t mps2_scc_read(void *opaque, hwaddr offset, unsigned size) } r = s->cfg6; break; + case A_CFG7: + if (!have_cfg7(s)) { + goto bad_offset; + } + r = s->cfg7; + break; case A_CFGDATA_RTN: r = s->cfgdata_rtn; break; @@ -211,28 +247,43 @@ static void mps2_scc_write(void *opaque, hwaddr offset, uint64_t value, * we always reflect bit 0 in the 'remap' GPIO output line, * and let the board wire it up or not as it chooses. * TODO on some boards bit 1 is CPU_WAIT. + * + * TODO: on the AN536 this register controls reset and halt + * for both CPUs. For the moment we don't implement this, so the + * register just reads as written. */ s->cfg0 = value; - qemu_set_irq(s->remap, s->cfg0 & 1); + if (cfg0_is_remap(s)) { + qemu_set_irq(s->remap, s->cfg0 & 1); + } break; case A_CFG1: s->cfg1 = value; - for (size_t i = 0; i < ARRAY_SIZE(s->led); i++) { - led_set_state(s->led[i], extract32(value, i, 1)); + /* + * On most boards this register drives LEDs. + * + * TODO: for AN536 this controls whether flash and ATCM are + * enabled or disabled on reset. QEMU doesn't model this, and + * always wires up RAM in the ATCM area and ROM in the flash area. + */ + if (cfg1_is_leds(s)) { + for (size_t i = 0; i < ARRAY_SIZE(s->led); i++) { + led_set_state(s->led[i], extract32(value, i, 1)); + } } break; case A_CFG2: if (!have_cfg2(s)) { goto bad_offset; } - /* AN524: QSPI Select signal */ + /* AN524, AN536: QSPI Select signal */ s->cfg2 = value; break; case A_CFG5: if (!have_cfg5(s)) { goto bad_offset; } - /* AN524: ACLK frequency in Hz */ + /* AN524, AN536: ACLK frequency in Hz */ s->cfg5 = value; break; case A_CFG6: @@ -240,6 +291,14 @@ static void mps2_scc_write(void *opaque, hwaddr offset, uint64_t value, goto bad_offset; } /* AN524: Clock divider for BRAM */ + /* AN536: Core 0 vector table base address */ + s->cfg6 = value; + break; + case A_CFG7: + if (!have_cfg7(s)) { + goto bad_offset; + } + /* AN536: Core 1 vector table base address */ s->cfg6 = value; break; case A_CFGDATA_OUT: @@ -353,6 +412,24 @@ static void mps2_scc_finalize(Object *obj) g_free(s->oscclk_reset); } +static bool cfg7_needed(void *opaque) +{ + MPS2SCC *s = opaque; + + return have_cfg7(s); +} + +static const VMStateDescription vmstate_cfg7 = { + .name = "mps2-scc/cfg7", + .version_id = 1, + .minimum_version_id = 1, + .needed = cfg7_needed, + .fields = (const VMStateField[]) { + VMSTATE_UINT32(cfg7, MPS2SCC), + VMSTATE_END_OF_LIST() + } +}; + static const VMStateDescription mps2_scc_vmstate = { .name = "mps2-scc", .version_id = 3, @@ -372,6 +449,10 @@ static const VMStateDescription mps2_scc_vmstate = { VMSTATE_VARRAY_UINT32(oscclk, MPS2SCC, num_oscclk, 0, vmstate_info_uint32, uint32_t), VMSTATE_END_OF_LIST() + }, + .subsections = (const VMStateDescription * const []) { + &vmstate_cfg7, + NULL } }; |