| Age | Commit message (Collapse) | Author |
|---|
|
The ReTurn from Exception (RTE) instruction loads the system register
(SR) with the saved system register (SSR). It has a delay slot, and
behaves specially according to the SH4 manual:
The SR value accessed by the instruction in the RTE delay slot is the
value restored from SSR by the RTE instruction. The SR and MD values
defined prior to RTE execution are used to fetch the instruction in
the RTE delay slot.
The instruction in the delay slot being often a NOP, it doesn't cause
any issue most of the time except in some rare cases where the NOP is
being splitted in a different TB (for example when the TCG op buffer
is full). In that case the NOP is fetched with the user permissions
and causes an instruction TLB protection violation exception.
This patches fixes that by introducing a new delay slot flag for the
RTE instruction. Given it's a privileged instruction, the RTE delay
slot instruction is always fetched in privileged mode. It is therefore
enough to to check for this flag in cpu_mmu_index.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Delay slots are indivisible, therefore avoid scheduling an interrupt in
the delay slot. However exceptions are possible.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
This will make easier the introduction of a new flag in the next
patches.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
When a masked exception happens, the SH4 CPU generates a non-masked
reset exception, which then jumps to the reset vector at address
0xA0000000. While this is emulated correctly in QEMU, this does not
work when using a kernel and initrd as this address then contain an
illegal instruction (and there is no guarantee the kernel and initrd
haven't been overwritten).
Therefore call qemu_system_reset_request to reload the kernel and initrd
and load the program counter to the kernel entry point.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
qemu_log_mask() is preferred over fprintf() for logging errors.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Use cpu_loop_exit_restore when using cpu_restore_state and cpu_loop_exit
together.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
SH4 requires that memory accesses are naturally aligned, except for the
SH4-A movua.l instructions which can do unaligned loads.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
At the same time change the comment describing the instruction the same
way than other instruction, so that the code is easier to read and search.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
We only emulate UP SH4, however as the tas.b instruction is used in the GNU
libc, this improve linux-user emulation.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
synco is a SH4-A only instruction.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
This doesn't change the generated code on x86, but optimizes it on most
RISC architectures and makes the code simpler to read.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Using extr and avoiding intermediate temps.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Reviewed-by: Richard Henderson <rth@twiddle.net>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
There is no need to save flags when entering and exiting the delay slot.
They can be saved only when reaching the end of the TB. If the TB is
interrupted before by an exception, they will be restored using
restore_state_to_opc.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
In case of exception, there is no need to call tcg_gen_exit_tb as the
exception helper won't return.
Also fix a few cases where BS_BRANCH is called instead of BS_EXCP.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
When stopping the translation because the state has changed, goto_tb
should not be used as it might link TB with different flags.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Instead of using one bit of the env flags to store the condition of the
next delay slot, use a separate global. It simplifies reading and
writing the flags variable and also removes some confusion between
ctx->envflags and env->flags.
Note that the global is first transfered to a temp in order to be
able to discard the global before the brcond.
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
DELAY_SLOT_TRUE is used as a dynamic condition for the branch after the
delay slot instruction. It is not used in code generation, so there is
no need to including in the TB state.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Now that ctx->flags has been split, it becomes clear that
DELAY_SLOT_CLEARME has not impact on the code generation: in both case
ctx->envflags is cleared, either by clearing all the flags, or by
setting it to 0. This is left-over from pre-TCG era.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
There is a confusion (and not only in the SH4 target) between tb->flags,
env->flags and ctx->flags. To avoid it, split ctx->flags into
ctx->tbflags and ctx->envflags. ctx->tbflags stays unchanged during the
whole TB translation, while ctx->envflags evolves and is kept in sync
with env->flags using TCG instructions. ctx->envflags now only contains
the part that of env->flags that is contained in the TB state, i.e. the
DELAY_SLOT* flags.
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
When running certain HMP commands ("info registers", "info cpustats",
"info tlb", "nmi", "memsave" or dumping virtual memory) with the "none"
machine, QEMU crashes with a segmentation fault. This happens because the
"none" machine does not have any CPUs by default, but these HMP commands
did not check for a valid CPU pointer yet. Add such checks now, so we get
an error message about the missing CPU instead.
Signed-off-by: Thomas Huth <thuth@redhat.com>
Message-Id: <1484309555-1935-1-git-send-email-thuth@redhat.com>
Reviewed-by: Markus Armbruster <armbru@redhat.com>
Acked-by: David Gibson <david@gibson.dropbear.id.au>
Signed-off-by: Dr. David Alan Gilbert <dgilbert@redhat.com>
|
|
We have never has the concept of global TLB entries which would avoid
the flush so we never actually use this flag. Drop it and make clear
that tlb_flush is the sledge-hammer it has always been.
Signed-off-by: Alex Bennée <alex.bennee@linaro.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
[DG: ppc portions]
Acked-by: David Gibson <david@gibson.dropbear.id.au>
|
|
It is a common thing amongst the various cpu reset functions want to
flush the SoftMMU's TLB entries. This is done either by calling
tlb_flush directly or by way of a general memset of the CPU
structure (sometimes both).
This moves the tlb_flush call to the common reset function and
additionally ensures it is only done for the CONFIG_SOFTMMU case and
when tcg is enabled.
In some target cases we add an empty end_of_reset_fields structure to the
target vCPU structure so have a clear end point for any memset which
is resetting value in the structure before CPU_COMMON (where the TLB
structures are).
While this is a nice clean-up in general it is also a precursor for
changes coming to cputlb for MTTCG where the clearing of entries
can't be done arbitrarily across vCPUs. Currently the cpu_reset
function is usually called from the context of another vCPU as the
architectural power up sequence is run. By using the cputlb API
functions we can ensure the right behaviour in the future.
Signed-off-by: Alex Bennée <alex.bennee@linaro.org>
Reviewed-by: Richard Henderson <rth@twiddle.net>
Reviewed-by: David Gibson <david@gibson.dropbear.id.au>
|
|
We've currently got 18 architectures in QEMU, and thus 18 target-xxx
folders in the root folder of the QEMU source tree. More architectures
(e.g. RISC-V, AVR) are likely to be included soon, too, so the main
folder of the QEMU sources slowly gets quite overcrowded with the
target-xxx folders.
To disburden the main folder a little bit, let's move the target-xxx
folders into a dedicated target/ folder, so that target-xxx/ simply
becomes target/xxx/ instead.
Acked-by: Laurent Vivier <laurent@vivier.eu> [m68k part]
Acked-by: Bastian Koppelmann <kbastian@mail.uni-paderborn.de> [tricore part]
Acked-by: Michael Walle <michael@walle.cc> [lm32 part]
Acked-by: Cornelia Huck <cornelia.huck@de.ibm.com> [s390x part]
Reviewed-by: Christian Borntraeger <borntraeger@de.ibm.com> [s390x part]
Acked-by: Eduardo Habkost <ehabkost@redhat.com> [i386 part]
Acked-by: Artyom Tarasenko <atar4qemu@gmail.com> [sparc part]
Acked-by: Richard Henderson <rth@twiddle.net> [alpha part]
Acked-by: Max Filippov <jcmvbkbc@gmail.com> [xtensa part]
Reviewed-by: David Gibson <david@gibson.dropbear.id.au> [ppc part]
Acked-by: Edgar E. Iglesias <edgar.iglesias@xilinx.com> [crisµblaze part]
Acked-by: Guan Xuetao <gxt@mprc.pku.edu.cn> [unicore32 part]
Signed-off-by: Thomas Huth <thuth@redhat.com>
|
