Age | Commit message (Collapse) | Author |
|
fprintf_function uses format checking with GCC_FMT_ATTR.
Format errors were fixed in
* target-i386/helper.c
* target-mips/translate.c
* target-ppc/translate.c
Cc: Blue Swirl <blauwirbel@gmail.com>
Signed-off-by: Stefan Weil <weil@mail.berlios.de>
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
|
|
Compiling with GCC 4.6.0 20100925 produced a lot of warnings like:
/src/qemu/target-mips/translate.c: In function 'gen_ld':
/src/qemu/target-mips/translate.c:1039:17: error: variable 'opn' set but not used [-Werror=unused-but-set-variable]
Fix by adding a dummy cast so that the variable is not unused.
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
|
|
The parameter for yield should be handled as a signed integer
for the comparisons to have any effect.
This also avoids a gcc warning with -Wtype-limits.
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
|
|
Signed-off-by: Edgar E. Iglesias <edgar@axis.com>
|
|
Signed-off-by: Hervé Poussineau <hpoussin@reactos.org>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Remove unused constant MIPS_FCR0
Signed-off-by: Hervé Poussineau <hpoussin@reactos.org>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Commit 36388314febad3d7675ab919287f03733a560ff6 moved most of the
interrupt logic to cpu-exec.c. Remove the remaining useless code
and fix software interrupts.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Acked-by: Edgar E. Iglesias <edgar@axis.com>
Tested-by: Edgar E. Iglesias <edgar@axis.com>
|
|
When hw interrupt pending bits in CP0_Cause are set, the CPU should
see the hw interrupt line as active. The CPU may or may not take the
interrupt based on internal state (global irq mask etc) but the glue
logic shouldn't care.
This fixes MIPS external hw interrupts in combination with -icount.
Signed-off-by: Edgar E. Iglesias <edgar@axis.com>
|
|
Loongson 2E and 2F use the same entry for xtlb and tlb exception, at
offset 0x000.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
This patch adds support for loongson 2E & 2F instructions. They are the
same instructions, but differ by the opcode encoding.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
|
|
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
|
|
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
|
|
Loongson CPU uses a load to zero register for prefetch.
Emulate it as a NOP.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Huacai Chen <zltjiangshi@gmail.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
TCGv t1 needs tcg_temp_free instead of tcg_temp_free_i32.
Cc: Nathan Froyd <froydnj@codesourcery.com>
Cc: Aurelien Jarno <aurelien@aurel32.net>
Signed-off-by: Stefan Weil <weil@mail.berlios.de>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Unlike MIPS16, microMIPS lets you choose the ISA mode for your exception
handlers. The ISA mode is selectable via a user-writable CP0.Config3
flag.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Add instruction decoding for the microMIPS ASE. All we do is decode and
then forward to the existing gen_* routines.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Change code handling mips16-specific branches to use ISA-neutral special
opcodes. Since there are several places where the delay slot
requirements for microMIPS branches differ from mips16 branches, using
opcodes is easier than checking hflags, then checking mips16
vs. microMIPS.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Move all knowledge about coprocessor-checking and register numbering
into the gen_cmp* helper functions.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Add FMT_* constants for the floating-point format field in opcodes and
tweak a few places to use them. Add enums for various invocations of
FOP and tweak gen_farith and its lone caller accordingly.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Acked-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Logging for -d cpu is done in generic code.
Signed-off-by: Richard Henderson <rth@twiddle.net>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
In the previous patch which introduced fprintf_function to
allow parameter checking by gcc some compiler warnings
remained unfixed.
These warnings are fixed here.
Signed-off-by: Stefan Weil <weil@mail.berlios.de>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
env->bcond must be printed using TARGET_FMT_ld.
Signed-off-by: Stefan Weil <weil@mail.berlios.de>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
QEMU uses a fixed page size for the CPU TLB. If the guest uses large
pages then we effectively split these into multiple smaller pages, and
populate the corresponding TLB entries on demand.
When the guest invalidates the TLB by virtual address we must invalidate
all entries covered by the large page. However the address used to
invalidate the entry may not be present in the QEMU TLB, so we do not
know which regions to clear.
Implementing a full vaiable size TLB is hard and slow, so just keep a
simple address/mask pair to record which addresses may have been mapped by
large pages. If the guest invalidates this region then flush the
whole TLB.
Signed-off-by: Paul Brook <paul@codesourcery.com>
|
|
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Disable various target specific code that is only relevant to system emulation.
Signed-off-by: Paul Brook <paul@codesourcery.com>
|
|
cpu_get_phys_page_debug makes no sense for userspace emulation, so remove it.
Signed-off-by: Paul Brook <paul@codesourcery.com>
|
|
Removes a set of ifdefs from exec.c.
Introduce TARGET_VIRT_ADDR_SPACE_BITS for all targets other
than Alpha. This will be used for page_find_alloc, which is
supposed to be using virtual addresses in the first place.
Signed-off-by: Richard Henderson <rth@twiddle.net>
|
|
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
When we signal a CpU exception for coprocessor 0, we should indicate
that it's for coprocessor 0 instead of coprocessor 1.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
In helper.c AREG0 may not correspond do env, so it's not possible to
call cpu_loop_exit() here. Call it from op_helper.c instead.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
|
|
Fix regression introduced by d19954f46dfc262612c30e9534e660e953049487.
4Kc and 4KEc don't support MIPS16.
Signed-off-by: Stefan Weil <weil@mail.berlios.de>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
4Kc, 4KEc cores do not support MIPS16, so not only the
CP0_Config1 had to be fixed (see previous patch),
but also MIPS16 instructions must not be executed.
(Hint from Nathan Froyd, thanks).
Signed-off-by: Stefan Weil <weil@mail.berlios.de>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Running programs with the MIPS user-mode emulator fails during dynamic
loading, as floating-point instructions are not enabled in in
env->hflags. Move the code for doing so from fpu_init to cpu_reset so
the MIPS_HFLAG_{FPU,F64} setting doesn't get clobbered by cpu_reset
setting env->hflags to MIPS_HFLAG_UM.
The same end can be achieved by swapping the ordering of fpu_init and
cpu_reset in cpu_mips_init, but it seemed better to consolidate the
CONFIG_USER_ONLY code into a single location.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Also cross off mips16 ASE in TODO.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
There's no good way to add this incrementally, so we do it all at once.
The only changes to shared code are in handle_delay_slot. We need to
flip ISAMode when doing a jump-and-exchange. We also need to set
ISAMode the low bit of the target address for jump-to-register.
Also, since we're now adding bits that can be in MIPS_HFLAG_BMASK_EXT,
make sure we use MIPS_HFLAG_BMASK_BASE in the places where we just want
basic information about a branch.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|
|
Move delay slot handling to common code whose invocation can be
controlled from gen_intermediate_code_internal.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
|