aboutsummaryrefslogtreecommitdiff
path: root/hw
AgeCommit message (Expand)Author
2007-11-05No functional changes: remove dead code and fix indentation & wrapping lines.j_mayer
2007-11-04Zeroing ITR shouldn't ack irq zero.balrog
2007-11-04 Change sysctrl register to 32 bits (original patch by Robert Reif)blueswir1
2007-11-04Fix memory corruption: bdrv_read/write API has been changed to takej_mayer
2007-11-04 Fix Solaris breakageblueswir1
2007-11-04Add register mappings in DSP space (must be accessible for MPU too).balrog
2007-11-04 Constificationblueswir1
2007-11-04 Remove target dependent codeblueswir1
2007-11-04Make accesses with wrong width also work as apparently real hardware allows t...balrog
2007-11-04Fix grackle (in fact MPC106) PCI host bridge headerj_mayer
2007-11-04Fix PowerMac NVRAM device.j_mayer
2007-11-03Split I^2C controller out of hw/omap.c.balrog
2007-11-03Implement OMAP on-chip RTC (Linux guest date/time now matches with host).balrog
2007-11-03Initial OMAP I^2C controller implementation (communication not tested).balrog
2007-11-03Add OMAP Pulse-width Tone module.balrog
2007-11-03Implement OMAP PWL (backlight) module.balrog
2007-11-03The PINT/DAV pin is active low in the chip spec, not inverted on the board.balrog
2007-10-31Add copyright and license header.ths
2007-10-31Set boot sequence from command line (Dan Kenigsberg).balrog
2007-10-31OHCI USB isochronous transfers support (Arnon Gilboa).balrog
2007-10-29Add a qemu_irq_invert() shortcut for inverting a signal.balrog
2007-10-29Add a TI TSC2102 chip (touchscreen/ADC/audio-CODEC controller).balrog
2007-10-29Fix PreP PCI IRQ mapping.j_mayer
2007-10-29Temporary hack to avoid Qemu crash at PowerPC reset time.j_mayer
2007-10-29Implement PreP reset port.j_mayer
2007-10-29PowerPC 601 / 620 / 970 need a 1MB firmware.j_mayer
2007-10-29Implement OMAP MicroWire controller.balrog
2007-10-28* sort the PowerPC target object filesj_mayer
2007-10-28Give an opaque to the m48t59 direct access routines to make it easierj_mayer
2007-10-28Add OMAP Shared GPIO module.balrog
2007-10-28Handle MMC card insertion/removal/readonly signals.balrog
2007-10-28Add PalmT|E matrix keypad connected to OMAP GPIOs.balrog
2007-10-28Implement OMAP1 MPU I/O module.balrog
2007-10-28Less debug noise from the mipsnet driver.ths
2007-10-21Bugfix: now PCI NICs really work on PowerPC PreP platform.j_mayer
2007-10-21Allow use of PCI NICs on PowerPC PreP platform.j_mayer
2007-10-20"QEMU keyboard issue with Gujin-2.2", by Etienne Lorrain.ths
2007-10-20Enable ACPI interrupts, by Igor Lvovsky.ths
2007-10-20Check the Galilleo config register instead of hardcoding the endianness.ths
2007-10-20Avoid PreP target kernel freeze waiting for IRQs.j_mayer
2007-10-18Only map BIOS space when it was actually loaded.ths
2007-10-17Second half of mipssim support, plus documentation improvements.ths
2007-10-14 SuperSparc MXCC support (Robert Reif)blueswir1
2007-10-14Implement time-base start/stop helpers.j_mayer
2007-10-14Fix memory corruption reported by Julian Sewardj_mayer
2007-10-14Do not allow PowerPC CPU restart after entering checkstop mode.j_mayer
2007-10-14Replace is_user variable with mmu_idx in softmmu core,j_mayer
2007-10-13Static-ify function.ths
2007-10-09Match values with the ones documented in the PIIX4 datasheet.ths
2007-10-09Fix vmmouse for 64bit guest, by Dan Kenigsberg.ths