diff options
| -rw-r--r-- | hw/rtl8139.c | 139 |
1 files changed, 84 insertions, 55 deletions
diff --git a/hw/rtl8139.c b/hw/rtl8139.c index f04dd5484a..72e2242723 100644 --- a/hw/rtl8139.c +++ b/hw/rtl8139.c @@ -41,6 +41,10 @@ * segmentation offloading * Removed slirp.h dependency * Added rx/tx buffer reset when enabling rx/tx operation + * + * 2010-Feb-04 Frediano Ziglio: Rewrote timer support using QEMU timer only + * when strictly needed (required for for + * Darwin) */ #include "hw.h" @@ -60,9 +64,6 @@ /* Calculate CRCs properly on Rx packets */ #define RTL8139_CALCULATE_RXCRC 1 -/* Uncomment to enable on-board timer interrupts */ -//#define RTL8139_ONBOARD_TIMER 1 - #if defined(RTL8139_CALCULATE_RXCRC) /* For crc32 */ #include <zlib.h> @@ -491,9 +492,12 @@ typedef struct RTL8139State { /* PCI interrupt timer */ QEMUTimer *timer; + int64_t TimerExpire; } RTL8139State; +static void rtl8139_set_next_tctr_time(RTL8139State *s, int64_t current_time); + static void prom9346_decode_command(EEprom9346 *eeprom, uint8_t command) { DEBUG_PRINT(("RTL8139: eeprom command 0x%02x\n", command)); @@ -2522,7 +2526,9 @@ static void rtl8139_IntrMask_write(RTL8139State *s, uint32_t val) s->IntrMask = val; + rtl8139_set_next_tctr_time(s, qemu_get_clock(vm_clock)); rtl8139_update_irq(s); + } static uint32_t rtl8139_IntrMask_read(RTL8139State *s) @@ -2555,12 +2561,22 @@ static void rtl8139_IntrStatus_write(RTL8139State *s, uint32_t val) rtl8139_update_irq(s); s->IntrStatus = newStatus; + /* + * Computing if we miss an interrupt here is not that correct but + * considered that we should have had already an interrupt + * and probably emulated is slower is better to assume this resetting was + * done before testing on previous rtl8139_update_irq lead to IRQ loosing + */ + rtl8139_set_next_tctr_time(s, qemu_get_clock(vm_clock)); rtl8139_update_irq(s); + #endif } static uint32_t rtl8139_IntrStatus_read(RTL8139State *s) { + rtl8139_set_next_tctr_time(s, qemu_get_clock(vm_clock)); + uint32_t ret = s->IntrStatus; DEBUG_PRINT(("RTL8139: IntrStatus read(w) val=0x%04x\n", ret)); @@ -2739,6 +2755,46 @@ static void rtl8139_io_writew(void *opaque, uint8_t addr, uint32_t val) } } +static void rtl8139_set_next_tctr_time(RTL8139State *s, int64_t current_time) +{ + int64_t pci_time, next_time; + uint32_t low_pci; + + DEBUG_PRINT(("RTL8139: entered rtl8139_set_next_tctr_time\n")); + + if (s->TimerExpire && current_time >= s->TimerExpire) { + s->IntrStatus |= PCSTimeout; + rtl8139_update_irq(s); + } + + /* Set QEMU timer only if needed that is + * - TimerInt <> 0 (we have a timer) + * - mask = 1 (we want an interrupt timer) + * - irq = 0 (irq is not already active) + * If any of above change we need to compute timer again + * Also we must check if timer is passed without QEMU timer + */ + s->TimerExpire = 0; + if (!s->TimerInt) { + return; + } + + pci_time = muldiv64(current_time - s->TCTR_base, PCI_FREQUENCY, + get_ticks_per_sec()); + low_pci = pci_time & 0xffffffff; + pci_time = pci_time - low_pci + s->TimerInt; + if (low_pci >= s->TimerInt) { + pci_time += 0x100000000LL; + } + next_time = s->TCTR_base + muldiv64(pci_time, get_ticks_per_sec(), + PCI_FREQUENCY); + s->TimerExpire = next_time; + + if ((s->IntrMask & PCSTimeout) != 0 && (s->IntrStatus & PCSTimeout) == 0) { + qemu_mod_timer(s->timer, next_time); + } +} + static void rtl8139_io_writel(void *opaque, uint8_t addr, uint32_t val) { RTL8139State *s = opaque; @@ -2784,13 +2840,16 @@ static void rtl8139_io_writel(void *opaque, uint8_t addr, uint32_t val) case Timer: DEBUG_PRINT(("RTL8139: TCTR Timer reset on write\n")); - s->TCTR = 0; s->TCTR_base = qemu_get_clock(vm_clock); + rtl8139_set_next_tctr_time(s, s->TCTR_base); break; case FlashReg: DEBUG_PRINT(("RTL8139: FlashReg TimerInt write val=0x%08x\n", val)); - s->TimerInt = val; + if (s->TimerInt != val) { + s->TimerInt = val; + rtl8139_set_next_tctr_time(s, qemu_get_clock(vm_clock)); + } break; default: @@ -3000,7 +3059,8 @@ static uint32_t rtl8139_io_readl(void *opaque, uint8_t addr) break; case Timer: - ret = s->TCTR; + ret = muldiv64(qemu_get_clock(vm_clock) - s->TCTR_base, + PCI_FREQUENCY, get_ticks_per_sec()); DEBUG_PRINT(("RTL8139: TCTR Timer read val=0x%08x\n", ret)); break; @@ -3105,6 +3165,7 @@ static uint32_t rtl8139_mmio_readl(void *opaque, target_phys_addr_t addr) static int rtl8139_post_load(void *opaque, int version_id) { RTL8139State* s = opaque; + rtl8139_set_next_tctr_time(s, qemu_get_clock(vm_clock)); if (version_id < 4) { s->cplus_enabled = s->CpCmd != 0; } @@ -3112,12 +3173,24 @@ static int rtl8139_post_load(void *opaque, int version_id) return 0; } +static void rtl8139_pre_save(void *opaque) +{ + RTL8139State* s = opaque; + int64_t current_time = qemu_get_clock(vm_clock); + + /* set IntrStatus correctly */ + rtl8139_set_next_tctr_time(s, current_time); + s->TCTR = muldiv64(current_time - s->TCTR_base, PCI_FREQUENCY, + get_ticks_per_sec()); +} + static const VMStateDescription vmstate_rtl8139 = { .name = "rtl8139", .version_id = 4, .minimum_version_id = 3, .minimum_version_id_old = 3, .post_load = rtl8139_post_load, + .pre_save = rtl8139_pre_save, .fields = (VMStateField []) { VMSTATE_PCI_DEVICE(dev, RTL8139State), VMSTATE_PARTIAL_BUFFER(phys, RTL8139State, 6), @@ -3231,59 +3304,20 @@ static CPUWriteMemoryFunc * const rtl8139_mmio_write[3] = { rtl8139_mmio_writel, }; -static inline int64_t rtl8139_get_next_tctr_time(RTL8139State *s, int64_t current_time) -{ - int64_t next_time = current_time + - muldiv64(1, get_ticks_per_sec(), PCI_FREQUENCY); - if (next_time <= current_time) - next_time = current_time + 1; - return next_time; -} - -#ifdef RTL8139_ONBOARD_TIMER static void rtl8139_timer(void *opaque) { RTL8139State *s = opaque; - int is_timeout = 0; - - int64_t curr_time; - uint32_t curr_tick; - if (!s->clock_enabled) { DEBUG_PRINT(("RTL8139: >>> timer: clock is not running\n")); return; } - curr_time = qemu_get_clock(vm_clock); - - curr_tick = muldiv64(curr_time - s->TCTR_base, PCI_FREQUENCY, - get_ticks_per_sec()); - - if (s->TimerInt && curr_tick >= s->TimerInt) - { - if (s->TCTR < s->TimerInt || curr_tick < s->TCTR) - { - is_timeout = 1; - } - } - - s->TCTR = curr_tick; - -// DEBUG_PRINT(("RTL8139: >>> timer: tick=%08u\n", s->TCTR)); - - if (is_timeout) - { - DEBUG_PRINT(("RTL8139: >>> timer: timeout tick=%08u\n", s->TCTR)); - s->IntrStatus |= PCSTimeout; - rtl8139_update_irq(s); - } - - qemu_mod_timer(s->timer, - rtl8139_get_next_tctr_time(s,curr_time)); + s->IntrStatus |= PCSTimeout; + rtl8139_update_irq(s); + rtl8139_set_next_tctr_time(s, qemu_get_clock(vm_clock)); } -#endif /* RTL8139_ONBOARD_TIMER */ static void rtl8139_cleanup(VLANClientState *nc) { @@ -3301,10 +3335,8 @@ static int pci_rtl8139_uninit(PCIDevice *dev) qemu_free(s->cplus_txbuffer); s->cplus_txbuffer = NULL; } -#ifdef RTL8139_ONBOARD_TIMER qemu_del_timer(s->timer); qemu_free_timer(s->timer); -#endif qemu_del_vlan_client(&s->nic->nc); return 0; } @@ -3356,12 +3388,9 @@ static int pci_rtl8139_init(PCIDevice *dev) s->cplus_txbuffer_len = 0; s->cplus_txbuffer_offset = 0; -#ifdef RTL8139_ONBOARD_TIMER + s->TimerExpire = 0; s->timer = qemu_new_timer(vm_clock, rtl8139_timer, s); - - qemu_mod_timer(s->timer, - rtl8139_get_next_tctr_time(s,qemu_get_clock(vm_clock))); -#endif /* RTL8139_ONBOARD_TIMER */ + rtl8139_set_next_tctr_time(s, qemu_get_clock(vm_clock)); return 0; } |