aboutsummaryrefslogtreecommitdiff
path: root/qdev-monitor.c
diff options
context:
space:
mode:
authorIan Main <imain@redhat.com>2013-07-26 11:39:04 -0700
committerKevin Wolf <kwolf@redhat.com>2013-07-26 22:01:31 +0200
commitfc5d3f843250c9d3bfa2bcfdb7369f4753a49f0e (patch)
tree7d9d31289930195a4184a75982bf1248de55add4 /qdev-monitor.c
parentf660dc6a2e97756596b2e79ce6127a3034f2308b (diff)
Implement sync modes for drive-backup.
This patch adds sync-modes to the drive-backup interface and implements the FULL, NONE and TOP modes of synchronization. FULL performs as before copying the entire contents of the drive while preserving the point-in-time using CoW. NONE only copies new writes to the target drive. TOP copies changes to the topmost drive image and preserves the point-in-time using CoW. For sync mode TOP are creating a new target image using the same backing file as the original disk image. Then any new data that has been laid on top of it since creation is copied in the main backup_run() loop. There is an extra check in the 'TOP' case so that we don't bother to copy all the data of the backing file as it already exists in the target. This is where the bdrv_co_is_allocated() is used to determine if the data exists in the topmost layer or below. Also any new data being written is intercepted via the write_notifier hook which ends up calling backup_do_cow() to copy old data out before it gets overwritten. For mode 'NONE' we create the new target image and only copy in the original data from the disk image starting from the time the call was made. This preserves the point in time data by only copying the parts that are *going to change* to the target image. This way we can reconstruct the final image by checking to see if the given block exists in the new target image first, and if it does not, you can get it from the original image. This is basically an optimization allowing you to do point-in-time snapshots with low overhead vs the 'FULL' version. Since there is no old data to copy out the loop in backup_run() for the NONE case just calls qemu_coroutine_yield() which only wakes up after an event (usually cancel in this case). The rest is handled by the before_write notifier which again calls backup_do_cow() to write out the old data so it can be preserved. Signed-off-by: Ian Main <imain@redhat.com> Signed-off-by: Kevin Wolf <kwolf@redhat.com>
Diffstat (limited to 'qdev-monitor.c')
0 files changed, 0 insertions, 0 deletions