From d735b620b58f2fdfddc8e641e9feac3c9671a49d Mon Sep 17 00:00:00 2001 From: John Snow Date: Fri, 12 Sep 2014 23:51:12 -0400 Subject: ide/atapi: Mark non-data commands as complete When the command completion code in IDE and AHCI was unified to put all command completion inside of a callback, "cmd_done," we neglected to ensure that all AHCI/ATAPI command paths would eventually register as finished. for the PCI interface to IDE this is not a problem because cmd_done is a nop, but the AHCI implementation needs to send a D2H_REG_FIS and interrupt back to the guest to inform of completion. This patch adds calls to ide_stop_transfer, which calls ide_cmd_done, inside of ide_atapi_cmd_ok and ide_atapi_cmd_error. This fixes regressions observed by trying to boot QEMU with a Fedora 20 live CD under Q35/AHCI, which uses ATAPI command 0x00, which is a status check that may cause a hang because we never complete, and ATAPI command 0x56, which is unsupported by our current implementation and results in an error that we never report back to the guest. Signed-off-by: John Snow Reviewed-by: Paolo Bonzini Signed-off-by: Stefan Hajnoczi --- hw/ide/atapi.c | 7 +++---- 1 file changed, 3 insertions(+), 4 deletions(-) (limited to 'hw/ide') diff --git a/hw/ide/atapi.c b/hw/ide/atapi.c index 6d52cda4cc..10218dfa3a 100644 --- a/hw/ide/atapi.c +++ b/hw/ide/atapi.c @@ -136,6 +136,7 @@ void ide_atapi_cmd_ok(IDEState *s) s->error = 0; s->status = READY_STAT | SEEK_STAT; s->nsector = (s->nsector & ~7) | ATAPI_INT_REASON_IO | ATAPI_INT_REASON_CD; + ide_transfer_stop(s); ide_set_irq(s->bus); } @@ -149,6 +150,7 @@ void ide_atapi_cmd_error(IDEState *s, int sense_key, int asc) s->nsector = (s->nsector & ~7) | ATAPI_INT_REASON_IO | ATAPI_INT_REASON_CD; s->sense_key = sense_key; s->asc = asc; + ide_transfer_stop(s); ide_set_irq(s->bus); } @@ -176,9 +178,7 @@ void ide_atapi_cmd_reply_end(IDEState *s) #endif if (s->packet_transfer_size <= 0) { /* end of transfer */ - s->status = READY_STAT | SEEK_STAT; - s->nsector = (s->nsector & ~7) | ATAPI_INT_REASON_IO | ATAPI_INT_REASON_CD; - ide_transfer_stop(s); + ide_atapi_cmd_ok(s); ide_set_irq(s->bus); #ifdef DEBUG_IDE_ATAPI printf("status=0x%x\n", s->status); @@ -188,7 +188,6 @@ void ide_atapi_cmd_reply_end(IDEState *s) if (s->lba != -1 && s->io_buffer_index >= s->cd_sector_size) { ret = cd_read_sector(s, s->lba, s->io_buffer, s->cd_sector_size); if (ret < 0) { - ide_transfer_stop(s); ide_atapi_io_error(s, ret); return; } -- cgit v1.2.3